Fixing PVC Water Pipes

by Jeff Williams

You might face leaking in your PVC water pipes in your home for example in your bathroom. Let’s see how to fix it by yourself at home.

The substance hardens at area temperature and is a area filling adhesive. It comes in 2 elements that are stored separately.

Both elements have a clay like consistency and mixing the 2 components together produces an exothermic reaction that readies the putty for use.

As compared to different types of adhesives, an epoxy putty has the power to fill in gaps and can be use as a half of a structure through molding. Using the adhesive in repairing PVC pipes is simple.

Prepare

First of all, you should 1st prepare the PVC pipes that you’ll repair before mixing the 2 parts along. Notice the exact leaking spots. If it is a slow leak that is hard to find, get a paper towel and wrap it around the realm where you suspect the leaks are. Take it off once a while and examine it for wet spots. Repeat this procedure until you find all the leaks.

Relieving Pipe Pressure

To unharness the water pressure from the pipes, turn off the water provide and turn on all the taps in your house. Cut the water off at the main provide to your house. This relieves pressure on the lines and keeps water from spraying all over you when you begin to figure.

Roughing the Surface

To create the epoxy adhere more strongly to the pipe surface, rough it up with a sandpaper. Use a hacksaw or a ratchet PVC cutter to chop the leaky section of pipe out. A ratchet PVC cutter makes this job straightforward. You’ll be able to get one at your local home improvement store.

Mixing

Clean and smooth surface and make certain that you just clean it thoroughly afterward as dried epoxy is terribly hard to remove. Knead the mixture along with your fingers – please wear the gloves to protect your skin – till it is mixed thoroughly.

Stop the Leak

To stop a leak on a PVC pipe, wrap it with the epoxy putty. Press it on and extend it by a minimum of an inch on both sides of the leak. If the leak happens to be during a fitting, cover the entire fitting with the putty.

Mixing the Right Amount

Simply mix what you can use in 3 minutes. Divide the world consistent with what you think that you’ll be able to do among the desired time and mix the putty as you get to each space. Use PVC glue and apply an ample portion to your pipe. Slide the coupling onto the pipe. Put glue on the new piece and slide it into the coupling. Repeat the identical procedure on the opposite end.

Curing the Problem

Although the epoxy putty will cure in around 10 minutes, it will take about an hour to set up utterly. Hence, you must wait as long before turning the water supply back on.

Checking for Leaks

To guarantee that you have done an effective repair, check the realm for additional leaks. If there are, you’ll repeat the procedure you probably did for the previous leaks. Let the PVC water pipes you’ve just mounted dry a minimum of 30 minutes. Then, turn your water back on and check for leaks.

{ 0 comments… add one now }

Leave a Comment